When DVB-ASI and DVB-SPI conversion is required.
The CV-1 is a unit that converts DVB-standard SPI signals to ASI signals.
Of course, it can also convert ASI signals to SPI signals, and the conversion direction can be switched with a single front-panel switch.
It also includes a through output, allowing you to obtain the converted signal while keeping the original signal flow intact.
In addition, the ASI input section is equipped with an equalizer function, which corrects waveform distortion that occurs during transmission before conversion.
※DVB (Digital Video Broadcasting) is an internationally approved standard for digital television broadcasting.
※Mounting brackets U-1 and U-2 are sold separately.
Specifications
| Product Type | DVB-ASI ⇔ DVB-SPI Converter | |
|---|---|---|
| Product Name | TS CaPID CV-1 | |
| Model Number | CV1-AS111HR | |
| Input / Output | Input: DVB-ASI ×1 or DVB-SPI ×1 | |
| Bitrate | DVB-ASI → DVB-SPI | |
| Conversion Direction | Selected with the INPUT SELECT switch on the front panel. OFF: DVB-ASI → DVB-SPI ON: DVB-SPI → DVB-ASI | |
| Output Mode | For DVB-SPI → DVB-ASI conversion, the output mode (burst / packet) is set with DIP switch 4 on the rear panel. Factory setting: burst mode | |
| Power | Supply Voltage | AC100V |
| Power Consumption | 6W | |
| Apparent Power | 12VA | |
| Operating Temperature / Humidity | 5 to 40°C, 30 to 80% RH (non-condensing) | |
| Dimensions (W × H × D) | EIA 19-inch rack, 1U half size 205 × 43.5 × 250 mm (excluding protrusions) | |
| Weight | Approx. 1.2 kg | |
| Accessories | Dedicated power cable (for AC100V) ×1 (*1) Instruction manual ×1 | |
| Limitations | Input/output cable length: DVB-ASI 200 m (5CFB) | |
| Options | Rack mount support angle U-1 (mount one unit in 1U) Rack mount support angle U-2 (mount two linked units in 1U) Inspection test report (included only on request) | |
| Related Products | 64QAM / 256QAM Demodulator (DMB-2-QAM) ISDB-T Demodulator (DMB-2-ISDBT) ISDB-S Demodulator (DMB-2-ISDBS), etc. | |
(*1) The supplied dedicated power cable complies with the Electrical Appliance and Material Safety Act. Always use the supplied cable. The unit itself is outside the scope of the Act; however, we perform an in-house test equivalent to the dielectric withstand test for non-specified electrical appliances and ship only units that pass.
