For DVB-S/S2 signal demodulation / simple IF monitoring
Key Features
- ASI output mode (ASI only): Packet / Burst selectable
- Output TS format: 188 / 204 bytes selectable
- Control & monitoring: Control and status monitoring via LAN or front panel (buttons / LCD), including transponder switching
- Monitoring parameters: BER (post-RS or post-BCH), C/N, receive level
- Remote monitoring: Status display via LAN using the bundled application
- External control: Supports TCP-based control and data acquisition (protocol available upon request)
- Alarm output: Equipped with alarm contact output
- TS output: Supports simultaneous output of DVB-ASI (2 ports) and DVB-SPI
Specifications
| Product Type | DVB-S/S2 Demodulator | |
|---|---|---|
| Product Name | TS CaPID DMB-2-DVBS2 | |
| Model Number | DMB2-A2S1HR-DVBS2 | |
| Input | IF ×1 (75Ω, F-type connector) * No antenna power output is provided. If required, please contact us separately. | |
| TS Output | DVB-ASI ×2 DVB-SPI ×1 | |
| Contact Output | D-sub 9-pin (female) ×1
* PhotoMOS relay contact output | |
| Power | Supply Voltage | AC100V–240V |
| Apparent Power | 20VA | |
| Power Consumption | 12W | |
| Receiving Frequency | 950 MHz to 2150 MHz | |
| Acceptable Input Level | -65 to -25 dBm | |
| Supported Standards | DVB-S2 DVB-S | |
| Operating Temperature / Humidity | 0 to 40°C, 30 to 80% RH (non-condensing) | |
| Return Loss | 950 to 2150 MHz: 2.0 dB | |
| Dimensions (W × H × D) | EIA 19-inch rack, 1U half size 205 × 43.5 × 250 mm (excluding protrusions) | |
| Weight | Approx. 1.3 kg | |
| Accessories | Dedicated power cable (for AC100V) ×1 (*1) | |
| Options | Rack mount support angle U-1 (mount one unit in 1U) Rack mount support angle U-2 (mount two linked units in 1U) | |
| Related Products | TS Monitoring System (AlertMagic T&S) TS Simultaneous Recording System (TSR-1000) | |
(*1) The supplied dedicated power cable complies with the Electrical Appliance and Material Safety Act. Always use the supplied cable. The unit itself is outside the scope of the Act; however, we perform an in-house test equivalent to the dielectric withstand test for non-specified electrical appliances and ship only units that pass.
